Answer Posted / sabyasachi sejpada
It is changed the equally voltage & frequency
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
Factory acceptance test. FAT. For 132 kv transmisstion towers what is that meaning and what are the tests commonly companies perform now days.
Can u tell me design of switch yard
How the over load setting for HT Motors calculated-provided in Numerical Relay
Define closed loop control system.
what is the difference between neutral and earth
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
HOE WE CAN IMPROOVE BY USE OF CAPACITOR
in electrical control panel. how can i choose the cable rating. (example - 11kw motor, 18-25A mpcb}
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
Can RCD's used to protect the VVVF drive if not why.
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
WHAT IS SHORT CIRCUIT STRENGTH OF 100 AMPS MCCB?
What is the difference between isolators and electrical circuit breakers? What is bus-bar?
what is (+) and (-) in generator field detector stand for?