Answer Posted / karnam seenu
Bar bending schedule can be prepared to find total consumption of steel for particular member diameter wise as per the spacing between bars & dia of reinforcement mentioned in the GFC drawings. Simple formula to find the same is Number of rodsxlength of each road x Unit weight of particular diameter of reinforcement = Weight of reinforcement in KN or kgs.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How do you calculate the power of centrifugal pump?
What is unit weight of normal concrete?
Why the finite element method is lower bound solution?
plumbing CPVC fitting FTE Brass full form
Power grids in two adjacent states(A&B) are interconnected. Can power grid in state A can be represented by Thevenin Equivalent Circuit. If not explain Why?
which is the cheapest type of flooring (say for using for 6 months in a factory building & dismantling it)?
In Rcc ratio calculation I wanted to know quantity of Steel also.
silt%= silt volume/ silt+sand volume is this right?
how to determine H- zone in a column? where it will occur?
what is Brest Wall?
Can we apply curing compound on ceiling (slab Bottom)
is there any thumb rule for calculating construction cost of the building with pile foundation per sft. area?
What is the quantity of cement in mix m20 concrete?
what is education Cess.
What is the maximum crushing load in Kg & crushing strength in N/mm2 for M25 & M 15 Grade concrete
