Answer Posted / nishad
Failure of AVR means AVR will not deliver the excitation voltage to the exciter stator winding. Hence, Exciter stator winding will not be able to generate any magnetic flux and there will be no any field voltage generate in exciter rotor winding and it will not feed any output voltage to rotating diode assembly. If the diode assembly fail to get the supply, it will not supply the voltage to the main rotor winding which used to make the main flux between main stator and main rotor, and as a result main stator winding will not generate any output voltage even if the DG continuous running.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what r PID controllers?why they r used?what is there purpose?plz Explain in detail
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
what is magnetizing and demagnetizing current in generator and motor?
how you will decide the distance between the power transformer and its fencing
what is servo motor and how to work it.
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
How I calculate the ELCB for circuit breakers?
what is the calculation method to design core and winding of a 200kva 3phase distribution transformer?
Differentiate between low pass, high pass and band pass filter?
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
Keywords: Die, Card, Coin, B/N 2 To 12
What is lifting power for 1 wb/m2 and 1 A magnet?
USE OF 8 WAY PAN ASSEMBLY
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?