How to design CT for connected with Transformer OLTC
operation? normally CT output design for 1A/5A range but
during OLTC Tap position changing time how to function the
CT?
Answer Posted / shiv shanker
Ct current protection device
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Leakage current,un balance current which relay using for high voltage transmission?
tell me some type of questions throught which i can prepare for exam and do my best
hi pal, i am vengatesh from tamilnadu(chidambaram),i have called for the written test for the post of jr executive(ELECTRICAL) of AAI ,I dont know about the question paper pattern,so any kindly help me to face the examination,post me the model question papers and some tips to write my examination to (vengi.annadurai@gmail.com)
What is the power factor of a transformer at no load?
explain PV modules in solar energy generation.
What is the resistance of the field winding of a d.c. Shunt generator kept low?
How i can calculate current of cable according to ares?
which is the most advanced form of SF6 BREAKER?Can we use other gases to quench the arc?
how to control the speed to switched reluctance motor
how was your last weekend.
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
CAN WE CALCULATE THE NEGATIVE SEQUENCE AND ZERO SEQUENCE REACTANCE OF A GENERATOR USING ONLY ITS RATED VOLTAGE, KW, PF AND SYNCHRONOUS REACTANCE??? IF YES, THEN HOW??