what is different between runout and concentricity in Gd&T
- 7 Answers
- 76452 Views
- NRB Bearings, Quantum, Sunder Industries, I also Faced
- E-Mail Answers
Answer Posted / raj
Concentricity can be measured okay with CMM. If some one measuring the iuter surface of a part holding in mandrel, what they are checking is actually the run out.
In general, Runout is sufficient to take care of circularity and concentricity which can be easily measured too.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the properties of fuel oil?
In si units, one ton of refrigeration is equal to ?
my dear friends i want to know about pattern of HPCL & SAIL written exam papers. so please send me the details.
What is the purpose of I.O. circulation before and after starting of engine?
How i injecter setting qsk series cummins engine and i can using click type torqurench or dial gauge type
Explain the rule to find specific heat of aqueous solutions.
alignment formulae for any two shafts for shim correction
Define refrigerant.
Where do you work in engineering company?
Which pump is more efficient centrifugal pump or reciprocating pump?
There is a block placed in between air and water. water is at 100 deg cel and air at 50. 1) Draw temperature profile. 2) Why is it curve in air and water?
What is a vee used for on the vee block?
What is the formula for 1 HP of a two-cycle engine?
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
Explain the advantages of cycloidal and involute gears?
