The cable area of cross section is 185 sq mm. How to convert this to the diameter.
- 7 Answers
- 14353 Views
- Syscon, I also Faced
- E-Mail Answers
Answer Posted / vishnu
PI X R*R = 185
R*R = 185/3.14 = 58.92
R=ROOT 58.92 = 7.675
D= 7.675 * 2 = 15.35
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How much minimum insulation required between 11kv/3.3kv transformer windings?
Dear friends I want to design busbar for1600 kva transformer(i.e2100 amps) what are all the factors to be considered before selectinga busbar what are all the standard sizes of busbars what is the formula for finding current of copper and aluminium busbar
how the testing of protection CT Testing done through Primary injection kit please describe in detail procedure...
how we start 40w tube light with 4 diodes,2capacitors,1 choke and without starter.(a product avilable in market which lights burnt tube lights also)
Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
why we cannot protect 100% winding of an alternator by using differential protection?
brief notes on ammeters
i need to now what will be the cable size to the following load, transformer to distribution panel distance 110m, load 1000kw, voltage 400v, pf 0.85, permissible voltage drop 2.0%, overhead line, atmospheric temperature 35 degree c.
Do inductive loads have distorted current waveforms ?
Earth has zero potential then what would be the neutral potential ?
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
what is the use of the puls transformer in UPS & how it works???????????
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
how to check regenerative load in drived motor
