how can change 12mmdia@150c/c bar spacing to 16mmdia
Answer Posted / daniel lemma
Let assume for 1m (1000mm) span
d1=12mm
s1=150 approx No. =8pcs
d2=16mm
s1=? approx No. =?
We have to use this formula
d1^2 / s1 = d2^2 /s2 So s2=266.66 and
approx Spacing 250mm, and
New approx No of bar will be 4pcs
Is This Answer Correct ? | 13 Yes | 2 No |
Post New Answer View All Answers
What are the different theories of failure under static load?
pls give me some basic informations in construction of a structure?
what is Brest Wall?
Can anyone tell me the sequence of the activities in a drawing room, kitchen & Toilet including civil work, finishing, electrical & plumbing fittings
Why should pumping be not used in case of concreting works?
indian standard split spoon sampler
What is the difference in painting using Roller and Brush? What is the paint consumption difference? As per IS one coat of painting is painting from left to right and top to bottom whether this can be done using roller ( Roller Stick height and feasibility) ?
I have completed building maintenance course in mcvc stream .. can I apply for the post of " sthapstya abhiyantriki sahayyak"?
4. Differentiate between NC and OC soils. Draw curves for (i) Stress vs Strain (ii) Volume charge vs Strain (iii) Pore pressure vs Strain for these soils
The mixture of different ingredients of cement is burnt at?
in staad pro. modelling for a parallel scissors chord truss, when i assigned roller support i.e fixwd but with all Fx, FZ, Mx, My and Mz release except Fy... the analysis results " in stability at a joint, with direction Mx or My..what could be the reason...anyone please explaing
At what point does a circle start losing area when being flattened?
is there any codal provision for soil cousion over the Hume pipe of Dia 1.2 m.
A rock anchor 3 1/2” in diameter is placed in rock. The which has an allowable shear strength of 1200 psi. Determine the required anchorage length to safely carry a 80 ton load using a 2.0:1 F.S
The properties of concrete HA-30 and how does it differ with M 30 (specify the important characteristics like workability,strength,mix design,slump test value)and what is the standard relating to it