Detailed working of a diesel generator set ?
Answer Posted / pankajkumar.s
Basically DG set is a combination of 4 Stroke Engine & Alternator.in DG set Engine is Used as Prime Mover.
A)Engine:-4 stroke Engine is Work in 4 stroke that is 1)Suction 2)Compression 3)Power 4)Exhaust.In suction stroke Air is taken From surrounding by using Air intake valve.In compression stoke with the help of piston Air is Compressed to High Velocity & High Pressure.In power stroke Fuel is injected by Drain valve.same time power is produce in power stroke.same power will pool down your piston downward.in Exhaust stroke after combustion of fuel some gases are produced same gases is exhausted with the help of exhaust valve.same piston is connected to crank shaft n crank shaft is connected to Alternator rotor .So that rotor is rotated as crank shaft rotates.
2)Alternator :Basically Alternator consist of Rotor Winding and Stator winding(also called armature).In rotor winding field is created,so Flux is cut by Stator winding.and according to faraday's law of electromagnetic induction Emf is produced in stator or armature winding.same output is coupled to your load.
Thanks & Regards,
Pankajkumar
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
describe the fully control circuit diagram of ac drives
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
CBCT selection
Draw the circuit of clapp oscillator?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
What is the general system requirement of alternator?
What happened when capacitor connect series in ac circuit?
What happen if 200 KVAR capacitor connected to power continuesly?
what is mean by dual digital protection in the relay field?
standard earthing rating for power line..
how to calculate the lightning arrester conductor @ no of earth pits required
why in the three pin plug all 3 pins are cutted ?
what is the difference between Power and Distribution transformers ?
how to control the speed to switched reluctance motor