Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ajesh kumar
Yes that the correct answer
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What was the hardest part of obtaining your engineering degree?
why oil lift in screw chiller during change of climate.
What is the purpose of scrapper ring
Causes of emergency trip of diesel engine
please let me know the book for preparing to section engi and loco pilot bangalore
Why centrifugal pump is not called as a positive displacement type of pump?
Car tyres are usually made of ?
Enumerate some trouble of fuel injection valve
Where can i see model papers for NLC graduate engineer test and RRB section engineer test
Explain the congressional space medal of honor?
What are the names given to constant temperature, constant pressure, constant volume, constant internal energy, constant enthalpy, and constant entropy processes.
What is representative elementary volume?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
Which is the hardest material on earth?
What will you do when scavenge fire happened?
