Interested to Buy Any Domain ? << Click Here >> for more details...
What is power factor? Whether it should be high or low ?
why?
- 9 Answers
- 33589 Views
- I also Faced
- E-Mail Answers
Answer Posted / deepanchakravarthi
Power factor correction is most important one. Transmission and distribution lines is constant power factor maintaining in constant cost or power
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
draw the block diagram of fire alarm?
how we calculate torque ? how we improve it ?where torque will either motor or generator ?
what is the size of ht cable of 33kv ht line and transformers ratings are 1 Mva and 5mva.please send formula also.
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
Differentiate between Zero and Negative sequence current
What is reactance, reluctance,capistance, pls give answeer in hinglish and be simply Jo asani we smajh m aa jaye
What are the three types of compensators?
The 3 phase Delta connection RB=440V, BY=350V,.......* is Line to Line voltage RY= ? And Formula....?
Tell me all plants load factors i.e which plant operating on which load?
What is transformation ratio what it describes?
Inverter. converter. Ups.MCB.solar.alternators. motors.
where lt & ht capacitor used
delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?
how could we calculate the no of outgoings from a 800 watt distribution board
