why we set -10 volt in vibration sensor output,why not +10 volt
Answer Posted / omar faruk
1. Noise are lesser added in negative voltage supply rather than positive supply.
2. To activate NPN transistor Negative Supply is mandatory.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
what is dc moter.
Please asked me How calculate DCS controller memory.
What is the diffrence between digital signal processing and discrete signal processing?
Why the ammonia and Nitric Acid level indicators is with millimeter ? and What is the conversion form millimeters that level indicator indicate to weight ?
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
What is the procedure of calibration of Load cell?
Isometric drawings are generated during _________________ phase of a project
How would you choose differential range?
Whatis the reset ofset and control system in instrumentation
Define the difference between a stable versus an unstable controlled system and some of the tools you might use to be able to detect when this is happening and assumptions used for control system application design that could contribute to instability
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
Why grounding is necessary? Give example with diagram.
in valve is constructed as per SME B 16.34, then which standard is used for fire testing of valve?.