Multi-step core is used in transformer to:
A) Increase the output
B) Decrease the cost of core material
C) Decrease the cost of copper
D) Increase the efficiency
- 1 Answers
- 8312 Views
- Accenture, I also Faced
- E-Mail Answers
Answer Posted / h
Decrease the cost of copper
| Is This Answer Correct ? | 18 Yes | 5 No |
Post New Answer View All Answers
what is the breaking capacity and making capacity of circuit breaker and how
how to ctrl motor by use of ac or dc drive.plz explain evdintly
HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
suri transmission
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
why does a dc machine has high efficiency while working as a generator than as a motor ..
How to set a Zone 1 distance relay for distribution feeder?
what is inter connected dc generator?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
wat is d diffr btw shunt coil and trip coil in VCB?
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
