Answer Posted / dharmendra bhagwagar
The pressure differential over a distance represents potential energy (like a voltage), and the kinetic energy of the flow is proportional to the square of the mean velocity of the flow
Reference https://www.physicsforums.com/threads/i-need-an-easy-explanation-for-a-flow-formula.121914/
Reference https://www.physicsforums.com/threads/i-need-an-easy-explanation-for-a-flow-formula.121914/
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
How will you calibrate PID controller? explain with example.
Identification of ss fittings, pilot valves, relief valve.
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
Which type of pressure can be measured by these elements?
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
Make Heater Process Logic.
What is the procedure of calibration of Load cell?
Why flow/pressure transmitter before control valve?
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
How servomotor controls throttle valve of TURBINE?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
How would you choose differential range?
How oil line flow measured?eplain about instruments used and working principle?
plz send me general of ongc
