Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bugti.ghalib@yahoo.com
when any vehicle enters in a curve of a road,centrifugal force pull the vehicle outward, to counteract this force an elevation is provided at the outer edge of curve for balancing the outward force and to reduce the overturning of vehicle ,this is called super elevation
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is Curtailing of R/F
Tell me about triple point of water.
Design a reinforced concrete combined footing (rectangular) for two columns located 3.60 metres apart. The overall sizes of the columns are 40cm x 40cm and 69cm x 60cm and the loads on them are 1000 kn and 1500 kn respectively. The space available for the width of the footing is restricted to 180cm. The S.B.C. of the soil is 280 kn/mm2 use M15 concrete.
How to calculate quantity of plum masonry in 1:3:7
what is the formula to find the sttel (bar)length in beam having bent up at l/4 t 45 degree & 60 degree.
In a beam,stirrups are placed closely at ends than at centre due to shear.similarly where would ties be closer to each other-at center or at ends in a column and slab.
What is the use of array command?
For the symmetrical continuous beam shown in figure, Prestressed with a force P = 1500 KN along parabolic curve as shown, compute the extreme fiber stresses over the central support for the uniformly distributed load of 24 kn/m. Use load balancing method.
If we are providing concrete joint in every 10m with water stopper in water tank wall then is it necessary to cut the steel at joint section?
In block work seawalls what is the purpose of slip joints?
what is yield and tensile strength of steel, if steel has yeilding strength of 60 psi than how much its tensile strength?
how much quantity of 1.5" nails and 2.5" nails are required for conventional formwork shuttering?
I used Etabs software to analyse a high-rise building. And I want to use templated UBC-codes inside to calculate the Seismic load. My question is: whether or not I have to control the seismic load by base shear load which is manual calculation? (just for more clarification: I can control this by input the scale factor into Eartquake definition in Etabs) I would highly appreciate your answer.
What is the difference between absorption & adsorption and sorption?
i need the syllabus for the direcr recruitement of executive engineers in andhrapradesh
