Answer Posted / dhaval solanki
Thermocouples connected in Series showing the average measured temperature.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
use of split range ? where it is used ? in which control loop it is used ?
what is vibration a part of proceess variable? if vibration is a part variables then how we minimize the actual vibration on machine on load,? vision of instrumentation contrl plz ans me IPGDL interview question
how the arrangement of equipments done in control room
How earthing can be checked????
How works weighfeeders in cement industry? what is the working principle?
what is span value and zero ? and how set ?
What is the use of GMV in turbine?
What are de-saturators?
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
what is piezoelectric transducer?give an example in power plant n state its principle?
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
How can you add value to this Industry if offered the job?