Dear sir i m presently working in power plant nd my question is if any pump give flow 18tph then how would i know that how much range flow tx installed their flow line for flow measurement plz give me ans
- 1 Answers
- 1888 Views
- HPSL, Infotech, I also Faced
- E-Mail Answers
Answer Posted / praveen kumar
If the pump discharge pressure 18tph means u need to fix transmitter 18×1.5=27kg/cm2.so the range of transmitter 0-27kg/cm2....even this calculation if u gng to provide the gauge also u have calculate line pressure × 1.5
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the basic difference between Modbus and CAN Open Protocols
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
Calibration of controller (pneumatic)
Draw block digram for well head from well to shipping pump?
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
what are procedure of sox-nox calibration
What are primary elements of measuring pressure?
What is Predictive Maintenance
Please tell me details about Sox,Nox,SWAS analyser????
what is scale factor of proximitor & unit of the vibration.
how to calibrate 0- 150 psi presure gauge by dead weght tester
how to work MIL contol valve posistioner ?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
Describe how to use megger to measure the earth resistance and insulation resistance
