Answer Posted / jalaramesh888@gmail.com
Dc is the most dangerous ac voltage. because of zero position ac cycle but dc is the no zero position because no cycle is not found straight direction in current
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the function of the circuit breaker failure relay?
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
What is the main use of rotary phase converter ?
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
what are the advantage and dis-advantage of 3 phase 4 wire energy meter?
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
difference bewteen reverse current and alternating current
What was your role in the silicon evaluation/product ramp? What tools did you use?
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
For an induction motor wat is the loading/unloading cycle duration or interms of L/UL ratio/ percentage?
A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is
WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM
mccb service sittings be done?
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
