BIOPROCESS ENGINEERING - EXAMPLE 14.1 : In differential centrifugation of cells with diameter D in centimeter, the square of D is given by D x D = [18n ln (RF / RI) ] / [ (RP - RFF) Wt ] where n is the fluid viscosity (poise), RF is the final radius of rotation (cm), RI is the initial radius of rotation (cm), RP is cell density (g / ml), RFF is the fluid density (g/ml), W the square for the rotational velocity in (radians / s) (radians / s), t is the time required to sediment from RI to RF (s). Derive an equation for W as a function for D, n, RF, RI, RP, RFF and t, with the stated units above, in radian & degree.
- 1 Answers
- 1672 Views
- I also Faced
- E-Mail Answers
Answer Posted / kangchuentat
BIOPROCESS ENGINEERING - ANSWER 14.1 : By algebraic formula, W = [18n ln (RF / RI) ] / [ (D x D) (RP - RFF) t ] where W is in (radians / s) (radians / s). One radian is approximately 57.288 degrees, then the W (radian) = (57.288) (57.288) W (degree) or W (in radian) = 3281.96 W (in degree). The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS +61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
hi all i have doe cheical engg, but i have to go for iob po interview so can anybody suggest me abt the kind of qns that can be asked.
What is a common failure mechanism for above ground atmospheric storage tanks?
Explain what are some good uses of low-grade steam at 12 atm and 1920c?
Explain how can I evaluate the thermal relief requirements for double block-in of 98% sulfuric acid?
How can we derive power factor equation p=vi cos phi?
what is the difference between car seal close/open valves and lock close/open valves?
What are the steps taken to operate a tank-blanketing valve?
i am a prefinal year student of polymer engineering .could you please send the latest question papers regarding entrace exam.
repected sir i have given gate exam today.......... if i ll get the better rank in that ....what is the next process .....shall i give another one test......or wat....i dint get properlly..... plz help me or mail me on Nish_gasti@yahoo.co.in
Is it advisable to cool a fin fan by spraying demineralized water on it?
How fouling effected the heat transfer rate?
Explain how can you determine the largest impeller that a pump can handle?
What are some good uses of low-grade steam at 12 atm and 1920c?
What are some common causes of control valve noise?
Hi. I have completed my masters in chemical engineering from M S University in year 2008 and now going to do MS Chemical engineering in Lamar University. I am planning to appear for interview in two weeks from now. What are the expected questions from VO regarding masters after masters ? and wat should i expect to give reply ? kindly give your suggestions. Thanks
