Distinguish between shunt and series field coil constructions.
- 2 Answers
- 11344 Views
- BEL, I also Faced
- E-Mail Answers
Answer Posted / issacsamuel
A shunt generator is a type of direct current electric generator in which field winding and armature winding are connected in parallel, and in which the armature supplies both the load current and the field current. A direct current (DC) generator, not using a permanent magnet, requires a DC field current for exitation.
A field coil is an electro magnet used to generate a magnetic field in an electro-magnetic machine, typically a rotating electrical machine such as a motor or generator. It consists of a coil of wire through which a current flows.
http://usawriters.org
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What is the Temperature to be set in Thermostat provided in Marshalling box of the Transformer / Motor.
PLS MENTION QUESTIONS ASKED IN IOCL INTERVIEW FOR ELECTRICAL EGG??
how does a submersible pump work..?
what are the different kind of cables used for transmissions?
Can anybody please refer the best and simple book for about Protection relays and in detail of all its protection ?
What is meant by reverse polarity and how it can be fixed?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
what is the voltage rating of chiller unit sensors
How does the slip regulator works as a startor
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
how open delta PT works & what is its construction?
What is the basis for framing the rules of block diagram reduction technique?
Minimum IR value of 1.1 kv grade 3.5c (300, 240,185,150,120,95,70,50,35,25) sqmm Aluminium XLPE cable and 4c (16, 10,6 & 4) sqmm cu arm cable between RY,YB,BR,RN,YN,BN,RE,YE,BE & NE.
How to calculate earth fault current for 6.6 KV , 50 HZ , 756 Amps , 3000 RPM , 0.8 PF generator
