Can any body give detail about orifice sizing?
- 5 Answers
- 8317 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / vijay
mainly depend type of orifice & beta ratio .4 to .8
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Difference between dcs and plc including date processing and architecture.
what is function of SCADA , and how is it work, explain with difination
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
how to measure draft pressure in transmitter pl. give its single line digram
pls give me presant awerness quistion and answer in my emailid.
How an rtd work, and what volts/current goes to a rtd to measure the resistance?
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
Explain signal isolator
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
key exchanges in wpa,wpa2,tls
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
what is actual drum level and compensated drum level?
