Answer Posted / mazari
Cage is used in control valve to control cavitation or to minimize it.
aftabmazari@yahoo.com
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
What is force balance principle? State some of its’ advantages.
all types instrumentation questions want
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
which type of signal used in instrument?
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
why we use cascade control and feed forward control in 3 element drum level control measurement of steam drum .what is cascade and feed forward control system ?give example .
hiii.... can any one provide me previous years question paper of hindustan petroleum for instrumentation engineering???
What is 1:1 redundancy ?
Explain PID, ON/OFF, Controls
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
for oil & gas industries which zone is normally preferred? why? give its example?
What are the type of bonnets in the control valves?
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.