why the tapping of transformer on ht side??????
- 12 Answers
- 38737 Views
- CTS, OPTCL, Visa Steel, I also Faced
- E-Mail Answers
Answer Posted / kornelius vattie
HV side of a transformer carries low current in comparison to the LV side of the same transformer. This low current promote little arcs during switching, limits the size of cables to be used, therefore it is also very economical to do tappings here. NB- the higher the Volts, the low the Amps.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
what is the principle of the single phase energy meter? and,what is the advantages and disadvantages of single phase energy meter?
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
What is critical disruptive voltage?
The moisture in air will condense at
What is resolver and glass scale in CNC how they work?
what happen when we add mentos in cold drink?& why?
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
derive DC RMS value for half wave rectifier?
Why we are using only Dyn11 tranformer in distribution system but not using a Dyn1 in distributing system?why not and advantage and disadvantage in both
what are the range of memory address in plc for L&T lx7 4A
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
What is proportional controller?
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
