Why do we need ring main unit (RMU). what is its purpose and its advantages . what is the operating function of rmu
- 6 Answers
- 36819 Views
- MahaDiscom, I also Faced
- E-Mail Answers
Answer Posted / kamal
1 when RMU connected to SCADA system we can detect line fault on the office room
2 AB Switch operation removed by RMU
RMU is nothing but AB Switch in simple word
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Explain how you decide what size of electrical wire do you need?
What is industrial plc
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
What facility we get after CT secondary earthing and how?
how we can do the insulation on secondary of ct explain and so that tan delta will within limit
Define unilateral circuit?
Calculate torque developed by the 3-phase, 5 H.P., 4 pole induction motor runs at 1500 rpm A 23 N-m B 21 N-m C 10 N-m D 0 N-m
how many types of motor can be used in washing machine
how to decide the capacity of accl
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
what is the minimum voltage require to injure our body?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
can you send me the placement papers of electrical engg. from companis like NTPC,DRDO,IOCL,HPCL,BPCL etc.?If,plz send as soon as possible.Thanks.
how dose servo motor works
Form S and "c" license application both are same? @ tneb portal
