Answer Posted / e hanumanthu
Three-phase electric power is a common method of alternating-current electric power generation, transmission, and distribution. It is a type of polyphase system and is the most common method used by electrical grids worldwide to transfer power. It is also used to power large motors and other heavy loads.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is frantic effect?
Define what is difference between fuse and breaker?
What is T’Q and X’Q and X’D ? and what is saturated as well as unsaturated ?
Cb closed condition if there is a tcs fail whether cb will trip or not
distribution is maximum done by a)radial b)network c) parallel d)b & c
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
how does a submersible pump work..?
one conductor length is L.and i am strech uniformly this conductor and made length is 2L.so resistance of this strech conductor is R=4R..but i want to know about area of stech conductor hows it become a/2..
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
what is meant by re-rolling motor? how it differs from standard motor?
Best way to measure the Soil resistance of rocky soil, three probe method and four probe method
Earth bits close or open. Which is correct
how much allowable resistance that can be difference in motor all coils?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
Pls explan the OLR setting in VCB at HT yard
