Interested to Buy Any Domain ? << Click Here >> for more details...
What motor is used in ceiling fans and what motor is used
in table fan.? why table fan is costlier than ceiling fan?
- 6 Answers
- 28781 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / amit mishra
Ceiling fans have a stationary armature and the motor moves in the counter-clockwise direction. Since, the blades of the fan are attached to the motor, the ceiling fan rotates in an anti-clockwise direction.It is exactly opposite for a table fan. The motor is stationary and the armature moves to give motion to the fan blades.According to Newton's third law the stationary motor gives the armature a push in the opposite direction. This causes the blades of the table fan that are attached to the armature, to move in clockwise direction.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
which is the most advanced form of SF6 BREAKER?Can we use other gases to quench the arc?
WHICH SIZE A.B.CABLE IS USED FOR 11KV.
Why do we apply both Differential and REF (HV and LV) protection schemes on YNyn configuration of a transformer?
what are the basic insulation levels & what its Unit
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
how to calculate percentage impedence at 75 deg C at normal tap
why transmission is only 3 phase and not 2 or 4 or poly phases
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
from generating station If 400v LT line length is 1000m how much voltage is drop and how do i calculate it? which cable will be use for this line?
What is meant by impedance? difference between high & low impedance ?
what mean by analog ,digital,numerical meters and relays? say the example?
Can anybody inform me about the pattern of ECIL GET( Graduate Engineers Trainee) interview for Electrical students? Will there be HR round as well? I thought of preparing for 2 to 3 subjects thoroughly. Will it be sufficient? Please share your thoughts.
how we do Vector group ,magnetic balance and tap changer test in Transformer?
