give the full form for upvc pipe & cpvc pipe
Answer Posted / aman gupta
PPR Pipes
| Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
what is conrete grade ,how are depent on concrete grad and size of concrete?
The building has 12 columns of 12x9 in 3 rows of 4 each in a plot of 50'x30', The central row is strengthened with 16mm twisted rods. The roof area is 1500 sft including balconies. calculate the load factor per sft. Also indicate the number of roofs the building can withstand.
suppose we have a tendency to make a hole on the surface of the simple supported beam, than where we goes to make it?
How to calculate Cement in bags ,sand in sqft and aggregate in sqft for 1cum M25 grade concrete
what is civil enginnering & what you need of this course?
What is the Hardness of M-40 grade concrete, general and theoratical
What is the quantity of metal 1 & metal 2 to be used in 100 cft concrete?
what should be the PCC ratio to construct a plinth of (40x40x4)ft...??also its estimated cost??
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
Differentiate first angle & third angle projection?
within an emergency scenario what are the safe systems of work a coss can setup as part of is duties
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
What is the distance between railway tracks?
How to hide dimensions in autocad?
What is Heavy Concrete & Normal Concrete