why the voltage level in transmission line are in multiple
of 11kV, 22kV, 33 kV etc..( i.e., 220 V )?
- 4 Answers
- 7327 Views
- I also Faced
- E-Mail Answers
Answer Posted / shirish
related to Form factor
F.F = RMS/Average value = 1.11 for only siounisidal wave- form
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what are the ''pitting rings''and how cn they be controlled in a series generator
Explain the laying procedure and laying depth of submarine/subsea power cable for 220/400KV system? Also available cable diameter?
difference between high and low impedance BUS BAR relay??
Whether amorphous core transformer is commercialized or not:Name of company making amorphous core transformer and what are different rating?
with help of neat sketch explain principle of TIG welding process
what happens when series resonance occurs?
Where servomechanism is used?
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
What happens if we run alternator on under frequency?
what is the role and fuction of automatic transfer switch in rotary ups
Hi everyone, I'm Lachuu, recently joined automation company as PLC Engineer. I have certain basic question, I request all big gurus and seniors to answer these question. Because this will be very helpful to me as well starters like me. How to design a control circuit (ex: pick & place - my current project) Yamaha robot PxYx series controller RCX222, using 6 cylinder double acting, plc keyence kv p16r 2 expansion unit for input and output each. How to select panel terminal mcb elcb powersupply. My main concern in some projects how to select dc power supply, mcb rcb(I came across dif bt b c d curves, but stil confusing, pls help me :-(. I would really appreciate all who are going respond to this question.
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
What conditions are required for transformer to operate at low frequencies ?
what are problems caused by the pdu in rack server
