how many rod are needed in 99sqft room .
Answer Posted / khan.altaf786@gmail.com
Area of Room : 99sqft
Convert in sqm
So: 99÷10.765= 9.1964sqmt
Assumed bar spacing 150mm
No.of rod=9.1964÷.150= 61.30 1=62.30
So sqmt 62x2=124rod
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the tensile strength of 10swg and 8swg gabion wire?
how to workable concrete cube test M-25 design mix
What is the requirement for over all CG of DG from the foundation surface to absorb the vibration of heavy set.
In cement concrete how to check a quality of material also proportion of material at site ?
how much tempareture are required to make liquid state of pid leed
How many square meter can a worker/labor demolish a structure per day?
Why are separation membranes used between concrete pavement slab and sub-base?
1) a)to prepare mortar for bricklaying how much amount of water should be added for its maximum strength and workability(to avoid cracks which results, when high quantity of water is added)?is their a formula or ratio? b) suppose we want to make 1:3 mortar,what is the best way to measure cement ,sand and water and how? c)time before which freshly prepared mortar should be used? d)proper way to mix and make mortar? e)when should curing start after laying bricks and for how long?and also how many hours per day? f)what is shear wall (please in terms of layman lol) bookish definisions are confusing.... g) and last,acc to codes what are max no. of course that should be laid in a day.
I just got a first job in Maharashtra and m a fresher. My task is estimate the cost of excavation of earth with J.C.B. can anyone tell me how to do this??
What is soil enforcement?
Dear Sir What is the Contraction joint for base Slab
how to calculate cut length of re-bar in a circle . because we not place same length of re-bar in whole circle maximum in center and minimum at corner so how to calculate middle bars???
The concrete slump recommended for beams and slabs; is?
how to calculate the mortar for 10'*10' size room for both plastering and for masonry work?
What Are The Different Type Of Slump Test Indications?