what is absolute separator, how it works, what are the types in it
- 1 Answers
- 2756 Views
- I also Faced
- E-Mail Answers
Answer Posted / p.v.k.phanindra
Absolute separator is a process to remove the minerals,salts,etc present in the water. This is because of redusing the corrosion effect& to improve the life time of BOILERS and Turbines, and improve the thermal efficiency of the plant
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
explain how the third harmonic content of the magnetising current affects transformer design
im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much
what is the difference between compensated & normal drum level in boiler drum?
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
why is the in steam turbine axial displacement of active side thrust pad is positive and non active side thrust pad is negative.
dear sir i have completed one year post diploma certificate in thermal power engineering from national power training institute durgapur ...plz suggest me for power sector job
procedure of how to generate power in solar plant.
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
By any way can we increase the B check hours from 300 to 500
what is the basic use of power plant in equipment
What is LB-SR.
what does mean by kva rating
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
