Q- Which of the following is Close loop system -
a-)respiratory System b-)traffic light system c-)washing
machine d-)Room heater
my option is A, what is our take on option B & C
- 4 Answers
- 5825 Views
- Sail, I also Faced
- E-Mail Answers
Answer Posted / uday
A) respiratory System is a close loop system.
Vertebrates have closed circulatory systems. Their blood flows through blood vessels (arteries, veins and capillaries) and they have a heart to push the blood around their body. The human circulatory system is a closed system.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
how do we commission inergen system?
How it the difference between force balance system and dispalacement balance system?
I wnat to practice more online type questions .so will you show them me to take a practice test?
why is an oxygen sensor used in a boiler stack
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
for oil & gas industries which zone is normally preferred? why? give its example?
What is hp & mp seperator .& what is its working principle ?
what is the calibration procedure for magnetic flow meter @ onsite
pls give me presant awerness quistion and answer in my emailid.
give eg of how I/P is used in control loops
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
