what is the main difference between simplex RTD and Duplex RTD?
Answer Posted / swapnil
main basic difference is simplex and duplex RTD is two point in duplux rtd if one point is damage in rtd then use in other point . so simple procedure and lower cost.
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
what types of cable used in underground coal mining?
what is the use of sdf?
How can calculate the earthing strip of Copper/GI for rating of 30kV,discharge current 10KA Lightning arrester.
what is the ATS .And how it works.
On what cycle does thermal power plant operate?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
how diside ct mf exmp.200/5 ct
what type of earthing do for dry fissure rock?
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables
Diagram on interconnectivity of 11kv transformer with RMU (i.e, one incoming and two outgoing or two incoming and one outgoing)
Why should we hire you over the others waiting to be interview?
Is a 300w induction motor used in a food processor as powerful as a 1000w DC motor.
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]