why synchronization done in clockwise direction?
- 12 Answers
- 21802 Views
- Hindalco, NTPC, I also Faced
- E-Mail Answers
Answer Posted / rajas
Synchronization should be done in CW direction , to avoid reverse power trip , because CW means your alternator speed and voltage is slight greater then grid ,after immediate synchronizing load will delivered to grid , other wise there is change of reverse power trip.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
what is the excess air in furnace
what do you mean by type zero control sytem ?Give an practical example of type zero contol sytem?
Match the following a)(X'+Y') b)X'Y' C)XY 1)NAND 2)NOR 3)Carry
What is the Difference between Ac Drives and Dc Drives? According to application, speed, Torque, cost, Reliability, Construction, Motor etc... Thankyou !!!
What is instrumental error?
how can i find cable size from current rating?
Difference between drift current and diffusion current?
What is the polarization index value ? (Pi value)and simple definition of polarization index ?
Explain about Leakage Test.
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
Why back emf used for a dc motor? Highlight its significance.
What are the advantages of speed control using thyristor?
how to calculate
WHY RATING OF VCB NOT LESS THAN 630A
