How to calibration of vibration probe
- 1 Answers
- 3202 Views
- Mina Al Ahmadi Refinery, I also Faced
- E-Mail Answers
Answer Posted / pravinsingh033@yahoo.com
Vibration probe is calibrated using Micrometer and TK-3 instruments. its depends on which type of vibration probe is used either Axial probe or Radial probe.
Axial probe- Bently Nevada TK-3 and
Radial probe- Micrometer.
This generally use to check the characteristics of the probe either it is healthy or not.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
Why MUX JB's are using only Temperature Element in Fundation field bus?
full process of gas turbin?
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
what is isloted barrier how it works and what are the main purpose.how it make safe area.
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
How to calibrate Toxic gas detector?
Draw symbols of the following :
what is the protection system in solar turbine compressor
whatis range of marcury filled tempereture gague
Can anyone convert a 5/2 way or 3/2 way valve into an ISO valve?
How to calibrate the flow transmitter
send me last 5 years questions asked in rrb chennai, for section engineer
hi! i want to know about mpse exam.
Galvanizing.
