If our power factor is lagging then who is in profit? I mean consumer or Supplier!
Answer Posted / ramakrishna
Supplier
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
When we connect the large capacitor bank in series ?
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
what is the difference between earth leakage and earth fault?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
what are the installation procedure of high voltage power transformer,CT,CB&PT?
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
what is the grounding Calculation formula? spouse i want to provide grounding to 3phase 18kw motor or i want to provide ground to 3phase 10kva dry type transformere or you give me any exemple...... Thanks.
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
What is difference between SMC supportg and Glass Fibre Reinforced Plastic Support.
How to decide CT & PT ratings for a given transmission line carrying some rated voltage?
Hi My dear all Friends, There is a question regarding HVAC Engineering and widely used in Power Projects. Question- What is the diffrence Between REF, SEF and Differential Protection....???? Where REF - Restricted Earth Fault SEF - Senstive Earth Fault.
Do Phase angle measurement have any application in freq/harmonics measurement? If so how?
What is the RME and explain the full form and what is the RME work?
how to calculate maximum current