What do you need to consider when installing a flowmeter
Answer Posted / karthik s
first we need to measure the pipe line length and diameter and flow rate of the liquid.Then we decided to which type of flow meter is required.
Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
State some of balance principle’ advantages?
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
Where Can i take a SPI INtools training in Mumbai? In Rolta India Ltd to whom I should approach regarding of SPI INtools Training?
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
what is performance test.need defination
Difference between dcs and plc including date processing and architecture.
why we are not using the turbine flow meter in the steam service?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
How works weighfeeders in cement industry? what is the working principle?
please send the drdo exam paper
why I need valve guard and whats different between guard and positioner ??
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.