how to find under ground cable fault ???
if our cable size is 95*4 then what will load capacity
with far mull
- 2 Answers
- 2519 Views
- Imdad, I also Faced
- E-Mail Answers
Answer Posted / pas
Disconnect the both side cable.after disconnect the cable check by meager meter.meager one lead for earthing second lead for conductor.reading show in mega ohm.if cable was short reading reading showing infinity.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the normal phase difference between the voltage and the no-load current in a transformer?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
.php|
Why AC current leads voltage in capacitor and how?
When we connect the large capacitor bank in series ?
what is the differebt between ac and dc fuse?
PIU how does work?
What is the tension required for the 25000 CFM AHU belt
how desiel generate sart fail of eb?
what is difference between window type and wound type transformers?where we will use window type and wound type transformers?
are there rmu for 3 transformer?
Define what is power quality meter ?
What is the Minimum winding resistance of motors ( small & big)? referance range
