how to carry out rate analysis for RCC work in column using M20 ?
Answer Posted / rajasekar
cost of M20 concrete and concrete mixing labour.The labour part may change from place to place.If it is hand mix, we have to consider the lead and lift of material.Shuttering and steel not to consider in the concrete volume.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
I have to design brick column and footing (note: without any reinforcement). Can somebody post me the design or suggest a book where i could possibly find the design? Plz help very urgent
in design case of structural member best suitrable percentage of steel limit is what
what is cement wastage percentage in NHAI ROAD WORKS
mean of NH4 pipe
primary treatment of sewagw consist of removal of floating materials removal of sand & grit removal of organic materials all above
What is the meaning of Brick- M 35 grade? Is it a common brick or it's a concrete brick?
How do you maintain water pressure?
How to plan a project
How to calculate ventonite bag in pile ( pile depth 25 m dia 1m)
how to calcualate the amount of stone,cement,sand required for 1cum of 450mm thick ruble stond masonary with ratio1:5, please me an answer with dtailed step
we want build 10ft height ,tostore 4 litresof water.what is theground basement for steel andcement andsand.please send us basment calculation?
Please let me know about answer for my Question as "What is the maximum wastage allowable of HYSD Steel in any Bridge project as per Code and Code reference also ?
material used for mendrel use to bend epoxy coated rebar
silt%= silt volume/ silt+sand volume is this right?