difference between a four point starter and three point
starter
- 9 Answers
- 76324 Views
- I also Faced
- E-Mail Answers
Answer Posted / saikat sshoo
In 4point starter a brass arc is present which is not present In 3point starter. A protective resistance is present In 4point starter which is not In 3point starter.
| Is This Answer Correct ? | 14 Yes | 5 No |
Post New Answer View All Answers
How do we calculate over and under frequency tolerance from generator data?
Tell me the reason of connecting domestic t/f primary in star or delta,and also secondary side.
Why do we perform an open-circuit test and short-circuit test on the transformer?
How to calculate the efficiency of Turbo Generator(Alternator) in general....?
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
what are the sample questions asking to the test cunducting for electrical superwising lisence test?
What are the difference between CT/PT operated Meter and RRAMR Meter for HT/LT application?
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
what is your aim
how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
I want to know the 'Test voltage' for Tandelta testing of 3.3 / 6.6 / 11 KV Motors. Please explain
how could we calculate the no of outgoings from a 800 watt distribution board
What are the basic elements used for modeling mechanical rotational system?
The size and construction of bushings in a transformer depend upon?
