if AVR fails in alternator. what will be the effect.
Answer Posted / s f ali
Actually when AVR damages, although the engine is running on fine RPM you will not having voltages like your required. I personally observed that engine was running on fine RPM and I was getting 14 L-N voltages.......
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
whats the application of voltage regulation? and whats the voltage regulation's device?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
why do we carry out winding resistance test?
plz send me the procedure and syllabus for mseb exam
how to protect motor in dol starter having capacity of 30 hp.40 hp?
What is Meter MF if External CT Ratio is 150/1 , PT Ratio is 132/110 Meter CT Ratio is 200/1 & Meter PT Ratio is 110/1
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
what type of earthing do for dry fissure rock?
WILL SCHNEIDER MAKE ACB(MASTERPACT)TRIP ON REVERSE POWER?
What happen in ups if phase reverse?
how hazordious area is classified at an oil & gas plant and categorise suitable class of electric equipment in that area like induction motors, LCS, Lighting Fixtures Fluerescent/Flood lights Mercury& sodium lights, J.Bs, Power Cables etc
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.