Interested to Buy Any Domain ? << Click Here >> for more details...
with out name plate details , how to find the metering ct
and protection ct.?pls brif explaination about that.
- 3 Answers
- 7891 Views
- APNPDCL, I also Faced
- E-Mail Answers
Answer Posted / prasad asolkar
if we have both metering and protection ct at same place and if they are applicable for a single application then the thicker sized ct is protection ct and the thinner sized ct is metering ct.
for eg.
rated current of dg is 1000A
then, metering ct will be 1000/5A & protection ct will be 500/5A.
so for smaller rated ct requires more no of turns at primary therefore the 500/5A ct have thicker winding & 1000/5A ct will have thinner winding.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is meant by class 1 E in electrical power supply?
What are linear and non-linear systems?
PAC and simple Ac different
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me
how can you size an automatic voltage regulator?
what is the difference between torque induced and torque load?compare them with respect to dc motor?
i have completed deee and i've (June2012-feb 2015 experience in electrical maintenance in pvt ltd company.company having HT & LT electrical power.how to apply electrical C-license ,NOW I was resigned my job,what are requirements of applying for c-license
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
how to erect roof control panel?
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
How npn and pnp transistor works
I use 20 nos led tube 4feet, in pathway 100mtr approximate, so what size cable i use for lighting
