what is the relationship between induction motor and
transformers?
- 11 Answers
- 31677 Views
- College School Exams Tests, Engineering, Reliance, I also Faced
- E-Mail Answers
Answer Posted / ganesh
very nice info on <a href="http://www.electricaledition.com/2015/11/differences-induction-motor-and-transformer.html">difference between transformer and induction motor</a>
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how to calculate the lightning arrester conductor @ no of earth pits required
State the frequency for rc phase shift oscillator?
Why efficiency in thermal power plant is low?
can the measured percentage error during calibration of single phase energy meter be negative?
What is difference between Sample test and Routine test in safety standard?
why in a swquence network representation, the negetive sequence generated voltage is taken as zero?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
why swinburnes test cannot be performed on series machines?explain
Z transform is use when system is not a) converges b) diverges
Mention the difference between Analogue and Digital circuit?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
why high speed tripping relay is used in protection circuit why not normal relay
