Does human body can effect the electric shock when stand on
Insulated material?
- 2 Answers
- 3867 Views
- I also Faced
- E-Mail Answers
Answer Posted / sourav pal
It depends,
1.Condition of body(non Linear Resistence) either wet condition or Dry condition.
2.Voltage Capacity(high/low)
3.On which insulator(capacitance) are u standing and touching the wire
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
Circuit diagram of tube light without starter using electrical choke
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
WHY RATING OF VCB NOT LESS THAN 630A
what is the basic construction diffrance between servo motor ans sqiralcage induction motor
Explain RLC circuit?
What are root loci?
to vary valtage from 0 - max a variac is necessary . so how to design for high power applications nearly about 200KW power
what is meant by 2 within a star in a voltmeter dial?
Anybody know how schematic diagram for reverse power relay? RPR for generator protection
Draw a block diagramof Three UPS systems connected in Parallel mode?
Why corona leads to production of Ozone and glow of the color VOILET?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
why booster transformer is used in sumpners test conducted on transformer????
