What is the volume of sand in per cubic meter if we have a design mix of concrete is 1:2:4 (by volume).
- 5 Answers
- 6826 Views
- I also Faced
- E-Mail Answers
Answer Posted / shamsideen mohammed sakwa
1:2:4=7, let's assume the area to be plastered is 100m2
0.012*100=1.2m3
2/7*1.2=0.3428572
You divide your ans by the volume of the tipper per trip,
0.3428572/3.82m3 per single trip
=1.3097145
Approximately = 1.31
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
step by step procedure to find out the percentage of steel in coloum,beam,slab,footing in detailed
What is the amount of work done by a carpenter, bar Bender and plaster Mason in interior and exterior plaster
Find out Cutting Length of Steel for Right angle Triangle? Where Opposite Side 4m, Adjacent side 6m. (Assume cover 40mm)
Define What are the materials used in building a gravity dam?
material required for construction of 1cu.mtr wall (Cement, No of bricks (Brick size 40cm x 20cm x 10cm),sand,Quantity of water
How to calculate ventonite bag in pile ( pile depth 25 m dia 1m)
For removal of formwork of simply supported slab / beam from where to start the deshuttering? ( Max Bending moment of the simply supported beam is in the center hence is it required to start from the supports?)
How many kilo-newtons equals 1000 kilogram?
Which brick is best for construction ,either fly ash or AAC BLOCKS
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
why we create short columns under grade slab?
please send latest placement papers of hpcl officers trainee test. i will be very thankful to you.
What is difference between limit state and working stress method? How it is applies in building structure.
pls tell me about method of cutting length of ties column
acceptance criteria for concrete works
