which one is dangerous AC Power r DC Power for Electrical
Shock ?
- 10 Answers
- 10683 Views
- I also Faced
- E-Mail Answers
Answer Posted / paramesha r l
I think AC is more dangerous.
Human body act as quasi capacitor due to contact resistance
Since Capacitor allows AC And Block DC severity of electric shock is less in DC.
In case contact is only one terminal I.e, + or - then severity is further less some time nil as there is no return path to source through human body.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What happen when change order of CT in GIS feeder?
What's mean HVF & HAF in Vacuum Circuit Breaker?
what is the use of piston rings in the engine used for a generator...........
Where is the best place to mount distribution panel in a house.
Between educational qualification and practical work experience, give us a brief explanation on your practical experience in your past Endeavour that you performed well to the satisfaction of your past or present employer?
A d.c. Shunt motor is found suitable to drive fans because they require?
What are the uses of lead compensator?
how is positive, negative, zero sequence is happen.. how is effect on 3 phase system
how wecalculate breaking capcity of acb mcb mccb .explain with example
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Match the following a)(X'+Y') b)X'Y' C)XY 1)NAND 2)NOR 3)Carry
what happens if earth of 33kv cable is not connected to earthing pits? please send this query's answer to ngrm.sudha249@gmail.com
I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience
