Answer Posted / hemant tiwari
3/2 SOV means 3 Ports (1 input, 1 output, 1 vent) and 2 ways (On & Off)
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
State some of balance principle’ advantages?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What you mean by multi stage control vavles?
how to calibrate load cell
I want to know the questions asked in ONGC interview(after being selected in the written exam) for Instrumentation branch.Kindly help.
What is the difference between mmwc and mmwg?
what is interface level and how it is calibrate?
Explain pH, Conductivity.
Identification of control valve parts.
What is heating effect?
how to calculate range of level transmitter?
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,
what is the responsibility of an instrument commissioning supervisor
What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?
