Interested to Buy Any Domain ? << Click Here >> for more details...
Relation between pyramids and electrical technology?
- 1 Answers
- 2606 Views
- I also Faced
- E-Mail Answers
Answer Posted / akula veerendra
In ancient days pyramids are used as genetic stations which are worked on principle of thermal power plant by using solar energy.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
define as synchronous generator
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
what is the advantages of having in-built acvvvf (without seperate inverter in the control panel)in the drive system of elevators?
draw singleline diagram of star to delta and dol starters
Why we are going for converter transformers for DC drives application instead of distribution transformer?
How would you calculate power loss in a resistor?
why industry prefer ht motor instead of lt motor.
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
what is counter poise conductors
what is the main function of capacitors in mccs.
how technical is calculated in 11kv line and lt line
How much load can take a 16 mm aluminum cable 3 phase
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
The screw thread commonly used for transmission of motion is one of the following types of threads
