Why is reating of t/f in kva but for inverter in kw ?
- 3 Answers
- 3868 Views
- UPPCL, I also Faced
- E-Mail Answers
Answer Posted / poonga
T/F losses depend on core and copper not on power factor .this is reason why it is being mentioned in KVA
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
If Polarization index of motor 8.75 at 500volts of medium voltage 4.16 KV motor what this mean winding good or bad pl answer if any reffrence book give me the link
1.what is the difference between ct and cvt? 2.what is the difference between pt and cvt? 3.what is the difference between relays and circuit breakers?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
what is mean by dry frequency
Can anyone tell me some hints about what type of questions are asked by the interviewer by an Electronics engineer when company is installing an IPP and wants a team of engineers?
why the arc welding machines require parallel earthing systems? ie why each machines are connected to earth pit by separate wires during earthing? wats it adavantages?
wish of these transformer uses oil?
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
rajha power sector details
what is the series parallel connection of capacitors? and how can we use these application in three phase motors for controlling torque?
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
The simple way of finding the leakage quantity and % in compressed air distribution system
What is the difference b/w fanuc alpha series 16i and 18i controller. what is stand for i
How calculated single phase induction motor req. Capacitor?
