Why we use negetive (-)voltage in vibration system
Answer Posted / chandrakant sahu
There is PNP type transistor used in ocsilator and also ti keep minimum interference negative voltage is suitable for this
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
Galvanizing.
what is effect of specific gravity in differential level transmitter , explain formula related with this .
what is diffrance between FF & SMART, explain with difination
what is the procedure of belt scale calibration?
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
Turbidity analyzer working principle ?
what are the diff. in servo and regulatory control?
Square root calculation for dp flow transmitter?
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
What is heating effect?
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
Why do we floating DC in DC system.