Interested to Buy Any Domain ? << Click Here >> for more details...
Single acting ON-OFF valve. it is air to open. when sov energized , valve will be open, so during that if air fail then what will be the condition of valve ( open or close ) ???
- 4 Answers
- 6029 Views
- I also Faced
- E-Mail Answers
Answer Posted / bibhutibhusan0
It will be remain in same condition if there is no air leakage and the valve is not spring loaded.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How does temperature bath work? How does coil gets heated only by applying some current?
how to calculate range of level transmitter?
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
in valve is constructed as per SME B 16.34, then which standard is used for fire testing of valve?.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Draw bode plot of any transfer function. Why is plotting bode necessary?
Calibration procedure for electro magnetic flow meter
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
how to calibrate and troubleshooting of leveltroll?
How to convert milliampares into flow??
What is the Working principle of Dozing valve?
Dear Sir/Madam,im going to attend Hpcl written exams on feb 17th in instrumentation stream..can anyone send me the HPCL model papers and pattern of HPCL ....i ve not yet attended anything in HPCL...so i dont know how it comes...so just i need some model test papers and pattern ..pls help me friends...
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
