Please give me a ansver for why currant transforme noe
point should erthing
Answer Posted / k.prakashchandra
To remove the leakage voltage from primary due to mutual capacitance
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
State kirchoff current law?
working function importance of mdc meter
what is metering cum synchronizing panel and how it is used?
What is the working mechanism of OLTC in Power Transformers????
where was current transformer protection units used and why??
What is the Temperature to be set in Thermostat provided in Marshalling box of the Transformer / Motor.
What is the pro & con of having 11kv & 33kv incoming, and what is the adv & disadv. of converting from 11kv to 33kv.
Single line diagram for dbb (double bus bar)system.
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
WHY RATING OF VCB NOT LESS THAN 630A
how solar power plant energy meter multiplication factor
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
what do u understand about FACTS? how they are useful?
What is use of starter and choke in tube light